Filter
Top Products
PAGE 68
Reference: Cloning Procedure Troubleshooting
• Procedure interrupted.
• Different TV models.
• Step(s) omitted or not performed.
• Insufficient cloning time.
• Cloning erratic.
- Wait until procedure complete message is displayed.
- Cloning is only possible with identical model TVs.
- Reread 50 - 51 - 52 pages to be sure all tasks were performed.
- Redo cloning and be sure learning/teaching time is about 1 min. and
5 to15 seconds (75 seconds).
- Reset Clone Programmer.
Warning: Do not use LT2002 while a LodgeNet PPV
card is installed in TV or clone programmer will be
damaged.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the programmer
behaves strangely after a static shock, activate the
internal reset switch and restore normal operation.
After a reset, check the real-time clock setting. It may
be necessary to reset the Clone Programmer clock from a
TV containing the correct time.
Note
The LT2002 programmer is designed to be used with TVs con-
taining the 221-01006 and later processors. Use with earlier TV
sets may give unpredictable results. Processors used before the
221-01006-04 have a limited screen display capability. They
cannot display entire screens as shown in the quick setup
instructions accompanying the LT2002 clone programmer. Use
the printed menu illustrations on the quick setup sheet supplied
with the Clone as an aid to making your programming choices.
(Although the menus are not all displayed, the clone functions
all operate normally.)
Clone Programmer Troubleshooting
Clone Programmer
Cloning Notes: While clone is copying or transferring a master setup, do not touch or otherwise disturb clone or connections between clone
and TV. Cloning a master TV setup should take at least 45 seconds. Transferring the master TV setup to the target TV should take at least 45
seconds. Monitor LED on clone to assure that the blinking heartbeat pattern is present throughout clone operations. After cloning, be
sure to disconnect power from the target TV for about 15 seconds.
Problem Possible Cause(s) Possible Solution(s)
Remote does not
operate clone.
• Wrong Installer remote. - Only use an appropriate Installer remote to operate clone program-
mer with TV/STB.
LED does not blink. • M.P.I. cord not connected.
• TV/STB not turned on.
• Weak batteries.
- Connect M.P.I. cord.
- TV/STB must be powered On for clone to work.
- Install 4 fresh AA high-quality alkaline batteries.
Clone menu hard to
read.
• Weak signal. - Connect TV/STB to a reliable Analog channel signal source.
No time set. • Time not available. - Set time on a TV, copy time to Clone Programmer.
Clone not working. • Clone programmer problem. - Try a different LT2002 Clone programmer.
- Reset Clone Programmer.
Clone Scans Channels
more than once.
• Clone should only scan
channels once.
- Retry cloning again.
Master and Other TV/STB
Cloning did not work.
Clone time disappeared. • Batteries were removed. - Batteries must remain installed to retain time settings.
New Setup not present. • TV/STB not reset. - Disconnect newly cloned unit from power for 5 seconds.
• After cloning operations are complete, just unplug the LT2002 from the TV/STB.
• If the TV/STB does not display a picture on the TV (blank screen) after a few seconds, just change channels.