Filter
Top Products
PAGE 50
Cloning Connections/Learning Setup
Connections for the LT2002 Clone Programmer to Learn the TV/STB Master TV Setup.
*Notes: It is assumed that the TV/STB is connected to a signal source, the source selected is Antenna (RF) In, the signal is from an
Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone
Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, the clone programmer LED is blinking
the required heart beat pattern, see above and next page.
*Notes: Once the clone is connected, do not touch the unit or otherwise disturb it or the MPI connections. Any disturbance while the
clone is operating may disrupt the master setup transfer or copying etc.
Before you begin cloning...
•The Master TV/STB should be connected to a good, stable sig-
nal from an over-the-air antenna or cable service Analog chan-
nel and connected to power. (See above.)
•Teaching and Learning is only possible between identical model
devices. (However, the LT2002 Clone programmer can store up
to 3 different ‘master’ setups.)
WARNING: Copying a blank or incorrect memory into a TV, STB or
other device will cause the TV, STB or other device to operate
erratically or become inoperable.
•Use an Installer’s remote to operate Learning and Teaching
menus.
•Make sure that the batteries in the Clone programmer are fresh.
• If batteries are removed, the Clone Clock time will be lost.
• Decide if you want to set the time from the Clone programmer
TV which has the clock set to the current time.
• Setting the time and transferring it to the Clone or other
device is a separate procedure.
• Follow the connection diagram above to connect the Clone to
a Master TV/STB display panel. After learning is
complete, to another identical TV/STB display panel to “teach”
it the master setup.
• After the TV/STB setup has been copied to another
identical TV/STB, that identical unit with the copied setup,
needs to be disconnected from power for about 15 seconds to
activate the newly-copied setup.
• See the Clone Troubleshooting section to resolve problems.
Turn to the next page to continue Cloning Setup.
RJP
INTERFACE
REMOTE
IN
AUDIO IN AUDIO OUT SERVICE
DISPLAY
CONTROL
AUX
CONTROL
DIGITAL
VIDEO OUT
AC IN 120V~60Hz
DIGITAL AUDIO
OUT (OPTICAL)
AC OUT 8A
DIGITAL
VIDEO IN
12
QuickSet II Programmer
LT2002
¤
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK= XX:XX
TV CLOCK= XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
. . . . . . . .
. . . . . . . .
. . . . . . . .
Ferrite Core
(TDK, ZCAT
2035-0930)
3.5mm Stereo Plug
with IR Receiver
DVI
RF Coaxial Wire
(75ohm)
Antenna
Wall Jack
AC Power
Cord