AVT 200HD Tuner • Operation 30
Reset Modes Summary
Mode Activation Result Purpose/Notes
1 Hold in the Reset button while
applying power to the tuner.
Restores the factory-installed firmware.
All user settings and files, such as audio
adjustments and IP settings, are retained.
Event scripts do not run when the tuner
is powered on in this mode.
Mode 1 can be
used to remove a
version of firmware
if compatibility issues
arise.
3 Hold in the Reset button until
the Reset LED blinks once (after
approximately 3 seconds); then within
1 second press Reset momentarily
(for less than 1 second).
Turns events on and off. During
resetting, the Reset LED flashes two
times if events are starting or three times
if events are stopping.
Mode 3 is useful for
troubleshooting.
4 Hold in the Reset button until the
Reset LED blinks twice (once after
approximately 3 seconds and again
after 6 seconds); then within 1 second
press Reset momentarily (for less than
1 second).
• Enables ARP capability.
• Sets the IP address, subnet address,
and gateway address to the factory
defaults.
• Sets port mapping to the factory
default.
• Turns DHCP off.
• Turns events off.
The Reset LED flashes four times in quick
succession during the reset.
Mode 4 enables you
to set IP address
information using the
ARP command and
the MAC address.
It does not replace
any user-installed
firmware.
5 Hold in the Reset button until the
Reset LED blinks three times (once
after approximately 3 seconds, again
after 6 seconds, and then again after
9 seconds); then within 1 second
press Reset momentarily (for less than
1 second).
Performs a complete reset to factory
defaults (except the firmware):
• Does everything mode 4 does.
• Resets almost all real time
adjustments:
• Clears the channel list, all presets,
and audio settings.
• Resets all IP options.
• Clears all files from the tuner.
The Reset LED flashes four times in quick
succession during the reset.
Mode 5 is useful if
you want to start over
with configuration
and uploading and
also to replace events.
