A SERVICE OF

logo

TW-H6W1IR ISDN Remote Router
Installation 19
The figure below shows how to make an Ethernet connection between
the router and a network end node.
Important Notes on Ethernet Connections
Observe the following rules when connecting devices with twisted-pair
Ethernet cables:
? ?For both end-node and uplink connections, use only EIA
Category 3 or higher-grade twisted-pair data cables with RJ-45
plugs. In almost all cases, only standard straight-through cables
are needed.
? ?Make sure no cable is more than 100 meters (328 feet) long.
? ?When uplinking two hubs together with a straight-through cable,
use an uplink-type jack at one end, and an end-node-type jack
at the other.