TW-H6W1IR ISDN Remote Router
Configuration and Management 55
or ISDN2) that is used to connect to the Internet. Also, if the Peer
IP is set as the default gateway here, you still need to define a static
default route in the Network Configuration, IP Static Route
submenu, but you don’t need to designate a gateway IP address for
the static route (the routers will automatically negotiate and adjust
the gateway IP setting accordingly). And also make sure that the
Remote IP Address in the Remote Networks Profile is set to
0.0.0.0. Note that only one ISDN circuit should be connected to
the Internet, and only one ISDN circuit (the same one) should be
the default gateway.
Dial-In User Profile
The Dial-In User Profile is used to configure the TW-H6W1IR for
single users (for example a person working at home) to dial in to the
router and gain access to the network. At least one User Profile must
be configured for each user who will dial in (in conjunction with Dial
Configuration settings). Please note that WAN connections to
computers on other networks must be defined in the Remote Network
Profile submenu.
Up to eight users can be set up to dial in to the router. However, more
dial-in users can be accommodated by using a Radius server as
described in the Radius Configuration section of this manual. Please
note that when a Radius server is being used, the Dial-in User Profiles
will be disabled.
The Dial-In User Profile submenu appears below:
