Filter
Top Products
Page 4-25CHAPTER 4 — PROGRAMMABLE FUNCTION STRINGS
LANDMAN
Use manual feed paper (sheet feed). If the System specifies manual feed
with the SCS Printer Setup command, and if the printer is in landscape
mode, this PFS will be sent to the printer. If the printer has more that four
paper drawers, this PFS can be used to access a fifth or sixth drawer.
However, automatic orientation selection works only for (P/L) PAPER
1>, (P/L) PAPER 2>, (P/L) PAPER 3>, and (P/L) ENVEL>. It does
not work for LANDMAN>.
JOG OUT
Move paper output tray to the other position (when the printer can output
paper to two positions). This is sometimes referred to as output offsetting.
This PFS is sent to the printer at the beginning of each page that requires
an offset when the System has sent an SCS Set Initial Conditions command
with the ic parameter set to FFh (DP), when the System has sent an SCS
Page Presentation Media command with the do parameter set to a value
other than 00h, or when the System has sent an SCS Page Presentation
Media command with the dd parameter changed from its last setting.
DEST1
Select paper output drawer 1. This PFS is sent to the printer at the
beginning of each page when the System has selected paper output tray
number 1 with the SCS Page Presentation Media command.
DEST2
Select paper output drawer 2. This PFS is sent to the printer at the
beginning of each page when the System has selected paper output tray
number 2 with the SCS Page Presentation Media command.
DEST3
Select paper output drawer 3. This PFS is sent to the printer at the
beginning of each page when the System has selected paper output tray
number 3 with the SCS Page Presentation Media command.
JSTSTRT
Start justification if the printer is capable of text justification. The user
must select the PRINTER setting for JUSTTYP= (under FMTINFO: for
the output port) for the OPTIMA to use this PFS.