Filter
Top Products
AGILE 5250 OPTIMA User’s Guide and ReferencePage B-32
The qq parameter controls the print quality at the target
printer by sending one of the PFSs LOWQUAL>
(qq=03h), MEDQUAL> (qq=01h) or HIQUAL> (qq=02h).
These PFSs are sent to the printer only if the print quality
setting is changed. Many target printers (specifically dot
matrix) place limitations on print quality, proportional
spacing, font and/or print enhancement combinations.
The OPTIMA supports the dx (duplex) parameter by
sending the SIMPLEX>, DUPLEX> or TUMBLE> PFSs
to the target printer whenever the parameter is changed.
275EMUL: No operation.
Command: Set Vertical Margins (SVM)
Format: 2B D2 nn 49 tmtm bmbm
Printers: 3812, 5219
Action: Specifies top and bottom margins for subsequent pages.
The tmtm parameter specifies the top margin in 1/1440-
inch units. Valid values are 0000h through 7FFFh. A
value of 0000h causes no change to the last setting.
The bmbm parameter specifies the bottom margin in
1/1440-inch units. This parameter is not used by 3812 or
5219 printers.
IBMEMUL: Same as IBM.
When in Computer Output Reduction (COR) mode, a
default half-inch margin is added to the top margin
requested by the system.
275EMUL: No operation.