Filter
Top Products
AGILE 5250 OPTIMA User’s Guide and ReferencePage B-22
Command: Justify Text Field (JTF)
Format: 2B D2 nn 03 rere pr
Printers: 3812, 5219
Action: Specifies that a field of text is to be justified.
Text to be justified follows the command. Justification
ends at the next Justify Text Field (JTF), Carriage Return
(CR), New Line (NL), Required New Line (RNL),
Interchange Record Separator (IRS), Form Feed (FF) or
Required Form Feed (RFF) command.
The left edge of the fields placement is the current print
position.
The rere parameter specifies the right edge the fields
placement in 1/1440-inch units relative to the left
margin.
The pr parameter specifies the percentage of white space
at the end of the field that is to be redistributed within the
field.
Allowed values of pr for 3812 and 5219 printers are 00h
(no change from last value), 32h (50%) and 64h (100%).
If the text to be justified does not fit within the field, no
justification takes place.
JFT cannot occur while Set Justify Mode is active.
IBMEMUL: Same as IBM.
The OPTIMA allows any percentage rule: 00h (no
change), and 01h (1%) to 64h (100%).
The OPTIMA turns off justify mode (as set by Set Justify
Mode) upon receiving this command.
The OPTIMA performs all calculations necessary to
perform the justification on the target printer. Because of
the complexity of these calculations, justification may
result in significantly reduced throughput.
The OPTIMA sends the PFS SNDXTRA> to the printer
between the characters in the text field to place small
amounts of additional space between the characters. This
results in the text being justified.
275EMUL: No operation.