Filter
Top Products
AGILE 5250 OPTIMA User’s Guide and ReferencePage 1-26
17. Press g. The display should read:
STOPS= setting
where setting is the default number of stop bits for the printer.
18. If the stop bit setting shown is not correct, use d and f to select
the proper setting. When the value is set, press ENTER. The display
should scroll to the right to read:
SERIAL1: STOPS=
19. Press f. The display should read:
SERIAL1: FLOW=
20. Press g. The display should read:
FLOW= setting
where setting is the default flow control setting for the printer.
21. If the flow control setting shown is not correct, use d and f to
select the proper setting. When the value is set, press ENTER. The
display should scroll to the right to read:
SERIAL1: FLOW=
22. Press s. The display will scroll to the left and should read:
CONFIG:SERIAL1:
SERIAL I/O PORT 1 is now configured. If not using any other serial
output port or any alternate host ports, the user may move to Saving the
Configuration.
To configure SERIAL I/O PORT 0 as an output port, simply repeat this
procedure for SERIAL0.