Filter
Top Products
AGILE 5250 OPTIMA User’s Guide and ReferencePage B-20
Command: Set Initial Conditions (SIC)
Format: 2B D2 nn 45 ic
Printers: 3812, 5219
Action: This command resets all system-changeable settings to
one of two sets of default values.
The ic parameter specifies the initial condition of the
printers settings. An ic value of FFh specifies the Data
Processing condition set (DP); an ic value of 01h
specifies the Word Processing condition set (WP).
DP WP
Page Width 13.2 inches 8.5 inches
Page Height 11 inches 11 inches
Left Margin none 1.5 inches
Right Margin 13.2 inches 7.5 inches
Top Margin none 1 inch
Bottom Margin 11 inches none
Typestyle (GFID) 11 87
Lines Per Inch 6 6
Auto New Line On Off
Auto New Page On Off
An ic value of FFh also specifies a job boundary.
On the 3812, an ic parameter value of FFh causes the
output tray to be jogged (offset).
IBMEMUL: Same as the 3812.
When the OPTIMA receives this command with the ic
parameter set to FFh, it sends the PFS JOGOUT> to the
target printer. This PFS is usually used to jog (offset) the
output paper tray.
Besides the target printer settings that are reset by this
command, the OPTIMA also sends the PFS JOBSTRT>
to the target printer if the ic parameter is set to FFh (DP).
By default this PFS is unused. It can be used to reset
duplex or 2-up print modes at the target printer, ensuring
that the last logical page from one job and the first