Filter
Top Products
4. Getting Started
4.4 Switching from operational mode to standby
Howtoswitchtostandby
1. Press the standby button on the remote control for 2 seconds.
A message : “Power down appears”.
Projector goes into standby. Standby LED blinks. After a while, the fans stop blowing and the projector switch off automatically.
4.5 Switching off the projector
Howtoswitchtooff
1. Press the standby button on the remote control for 2 seconds.
A message : Power down appears.
Projector goes into standby. Standby LED blinks. After a while, the fans stop blowing and the projector sw
itch off automatically.
2. Press the main power switch on the projector.
4.6 Temperature error DMD
Overview
When the temperature of the DMD is too low or too high, the projector will switch automatic
ally to standby. The LED on the projector
flashes 8 times and an automatic shutdown is activated.
4.7 Using the RCU
Pointing to reflective screen
Point the front of the RCU to the reflective screen surface.
A
C
B
Image 4-3
Via reflective screen
Direct pointing to the IR sensors
Point the RCU to any of the remote sensors, lo
cated on the front, top and the rear of the projector. The remote control can be used
up to 9 meters from the projector and within a 45 degree angle with respect to the sensors.
28
R5976763 CINEVERSUM 60/70 22042004