Filter
Top Products
9. Installation menu
9.6 When no signal
What can be done ?
When the projector does not detect an input source, it can be set up to switch automatically to stand by after a certain time which
can be set up during installation.
’When no signal’ set up.
1. Push the cursor key ↑ or ↓ to highlight When no signal. (menu 9-18)
2. Press ENTER to select.
The When no signal menu appears. (menu 9-19)
3. Push the cursor key ↑ or ↓ to highlight Shutdown.
4. Press ENTER to toggle between ON and OFF.
ON The projector shuts down after a certain delay. The delay menu item becomes active and can be set up.
OFF
The projector remains active and waits until an input signal is back.
5. Is Shutdown set to ON?
If yes, Push the cursor key ↑ or ↓ to highlight Delay (min).
The Modify delay window opens. (menu 9-20)
6. Use the ↑ or ↓ key to enter a new value.
The delay can be between 1 and 10 minutes.
Installation
Input slots
File service
Internal pattern
When no signal
Source transition
OSD configuration
Language
V-Keystone
H-Keystone
Global keystone
Orientations
Back
Menu 9-18
When no signal
Shutdown : ON
Delay (min) : 1
Back
Menu 9-19
Modify delay
Enter new value :
1
Back
Menu 9-20
9.7 Source transition
What can be done ?
While switching from one source to another, the time between (transition time) can be filled up with a typical background color.
Available colors:
•Black
• Green
•Blue
R5976763 CINEVERSUM 60/70 22042004
63