BenQ VA261 Flat Panel Television User Manual


 
The On-Screen Display (OSD) menu
27
Tuning the TV to your region
If you purchased this TV for use in Australia, it is ready to operate out of the box. However, if
you purchased this TV for use in a country other than Australia, you will need to perform the
'Auto-Installation' setup so that the TV can tune to the local available TV stations.
Both the 'Auto Installation' and 'Manual Installation' menus contain sub-menus which allow
you to select the country and PAL TV standard which the TV will use for channel selection.
See "Performing Auto installation" and "Performing Manual installation" on page 27.
Performing Auto installation
1. From the Setup menu, press or to select Auto installation and then press OK.
2. The Country menu item will be selected. To change it, press OK, and then press or to
select the country where the TV is installed. Press OK to confirm.
If you select 'Australia' or 'New Zealand' as the country, the known TV channel frequencies for
those countries will be scanned by the TV tuner to determine your local operating TV stations.
If 'Others' is selected as the country, all frequencies for the selected PAL TV standard will be
scanned. (The PAL standard used during the scan is selected in the next step 2b.)
2b.If 'Others' was selected as the country, press or to select Standard, press OK, then press
or to select the PAL TV standard appropriate for your country, (PAL B/G/I/D/K) and
press OK.
3. Press or to select Start installation, press OK, then press or to select Ye s , and press
OK. The TV will start searching for available channels to install them. This may take several
minutes, depending on which type of scan is being performed. Please let it complete the scan.
After the scan has finished, the TV will display the first station found. You can now view the TV
channels it located.
If you had selected 'Others' for the country, the TV sequential channel list will contain channels
in the order it found them, placing them sequentially from position zero. If you wish to remove
any unused or unwanted channels from the sequential channel list, see "Skipping a channel in
the sequential channel list" on page 28. If you wish to change the order or position of the
channels stored, see "Swapping channels in the sequential channel list" on page 29.
Otherwise, press MENU twice to close the OSD menu.
Performing Manual installation
The manual installation feature allows you to manually add TV channels or change the channel
positions in the sequential channel list.
Please consult your local TV stations for PAL TV standard type and designated frequency.
1. From the Setup menu, press or to select Manual installation and then press OK.
2. The Country menu item will be selected. However, you shouldn’t change it in this dialog.
If you want to change the country, you should only so so in the 'Auto installation' menu, then
perform a full 'Auto installation' scan. See "Performing Auto installation" above.
2b.If 'Others' was selected as the country, you can change the PAL standard. However, you
shouldn’t change it in this dialog. If you want to change the standard, see "Performing Auto
installation" above.
3. Press to select CH No, and then press OK. Pressorto select a position in the sequential
channel list for this channel, and then press OK.
If the selected channel number is child-locked, you must enter the password to continue.
4. Press to select Frequency, and then press OK. Pressorto move among different digits,
and then press the individual channel selection buttons to enter each digit of the frequency.
When done, press OK.
5. Press to select CH name, and then press OK. Pressorto move among different
positions, and then press or to select a desired character. When done, press OK.
6. Press MENU twice to close the OSD menu.
Downloaded From TV-Manual.com Manuals