Filter
Top Products
Section 1: Quick Start Guide
5
Test the remote control
6. View the TV channels
Press Power on the remote control (as highlighted in the
illustration). The TV should turn on, and the power indicator change to
green. If so, progress to the next step "6. View the TV channels" below.
If the TV does not turn on, first check that the power is available
(the power indicator will be lit red).
If so, try pressing Power on the right side of the TV. If the TV turns
on by this method, the problem lies with the remote control.
In that case, check that the remote control batteries are properly
installed. If need be, replace the batteries with new or known good
ones. See "Troubleshooting" on page 38 for further assistance.
To turn off the TV, press Power on the right side of the TV, or Power on
the remote control again, and the TV will return to standby mode (the
power indicator will turn red.)
Turn the TV on and select 'TV' as the input by pressing INPUT. The
channel number will display in the upper right corner of the TV screen.
See "Switching inputs" on page 18.
This TV series is factory set for Australia. It already has the Australian
TV station channels pre-tuned ready for instant use. If you purchased
this TV for use in Australia, it is ready to operate out of the box.
If you purchased this TV for use in a different country than
Australia, you will need to perform the 'Auto installation' setup so
that the TV can tune to the local available TV stations.
See "Tuning the TV to your region" on page 27.
To change to a channel directly, select the channel number using the
numeric channel selection buttons on the remote control (as
highlighted in the illustration). For example:
• to select channel 8, press .
• to select channel 28, press , .
See "Changing channels" on page 19.
By default, all of the possible Australian TV channels are added to the
sequential channel list (available through the Channel up or down
buttons). You should perform the 'Auto installation' setup so that only
the channels available in your local area are added to the sequential
channel list (and all others are skipped).
See "Performing Auto installation" on page 27.
To change to the next channel in the sequential channel list:
• Press CHANNEL or CHANNEL on the remote control (as
highlighted in the illustration) or CH or CHon the TV.
If you wish to remove any unused or unwanted channels, see
"Skipping a channel in the sequential channel list" on page 28.
If you wish to change the order or position of the TV channels, see
"Swapping channels in the sequential channel list" on page 29.
To return to the previous viewed channel or input, press RECALL (also
highlighted in the illustration).
Downloaded From TV-Manual.com Manuals