BenQ VA261 Flat Panel Television User Manual


 
Section 1: Quick Start Guide
4
5. Activate the remote control
1. Locate the remote control and batteries from the packaging, and unwrap them.
Be cautious when handling batteries. See "Warnings" on page 40.
Remote control usage tips
Do not let the remote control become wet, or place it in humid environments (like bathrooms.)
If the remote control sensor window on the TV is in direct sunlight or strong light, the remote
control may not operate properly. In this situation, change the light source or readjust the
angle of your TV, or operate the remote control from a location closer to the remote control
sensor window on the TV.
2. Turn the remote control end up to reveal its base, and open
the lid of the battery compartment by using a small coin or
similarly curved object to rotate the slot 90° anticlockwise.
The lid is spring loaded and will popup and come loose
from the remote control body.
3. Insert the batteries (supplied) ensuring that the positive and
negative marked battery terminals match the (+) and (-)
marks in the battery compartment.
Note that these batteries are provided for your
convenience so that you can operate the TV straight
away, however they have been stored with the TV for
some time and are no longer fresh. You should replace
them as soon as possible.
4. Refit the lid of the battery compartment by inserting the
hinge into the recess at one edge and levering the lid down
into position with the thumb of the hand holding the
remote control body.
5. Whilst holding the lid in place in this manner, use your
other hand and a small coin or similarly shaped object to
rotate the locking slot 90° clockwise locking the lid in place.
Point and aim the top front of the Remote
Control directly at the TV when pressing the
buttons.
The remote control must be held at an angle
within 30 degrees of the TV's remote control
sensor window to function correctly. The
distance between the remote control and the
sensors should not exceed 5 metres.
Do not cover the sensor window on the front
of the TV (below the power indicator lamp),
or place objects in front of it which will block
the direct line-of-sight between the Remote
Control and the sensor window on the TV.
30 degrees
5 metres
Downloaded From TV-Manual.com Manuals