Filter
Top Products
Digital Video Recording
59
Recording Options
Recording Events without Record Plus
While in Dual Mode with Record Plus disabled, you can set up the satellite receiver to
record one program from both locations (TV1 and TV2) at the same time.
1 Find a program to watch as described on page 28.
2 Press RECORD. A message will display asking whether you want to record the remainder
of the program. Select OK to begin recording now.
3 Press DVR. The DVR Event screen will open. You should see the program that is
recording indicated by the red dot next to the listings.
4 Select a program that you recorded earlier (one that is not recording now), then select
Start or Start Over. You should now be watching a pre-recorded program while the
receiver is recording the other program.
RECORDING OPTIONS
When you set up a timer, you can choose from the following options:
• Stop Recording Manually - The receiver will record until you press STOP.
• Extend End Time - You can extend the stop time for the recording. This option is
useful for programs that might run overtime, like sporting events or awards shows.
• Create a Recurring Timer - You can set up a timer like the one described in Setting
Up an Automatic Timer on page 66.
• Record the Entire Event - The receiver stops recording at the end of the event. This
selection is available only if the receiver was tuned to the channel at the beginning of
the program.
Note: If you tune to a program after it starts, you can record only the part of the program
after you tune to it.
Chapter 9 Two Color.fm Page 59 Tuesday, December 20, 2005 12:20 PM