Filter
Top Products
Chapter 11
86
Using Shared View
USING SHARED VIEW
Shared View is a feature of Single Mode that lets you activate the TV2 audio and video
outputs to display the same programming as the TV1 outputs. While using this feature,
both the Remote Control 1 and Remote Control 2 for your satellite receiver can control
what is displayed on all TVs connected to the system. This feature is available only in
Single Mode.
Note: Make sure you are using Remote Control 1 and TV1 because you cannot enable or
disable this feature using Remote Control 2.
Note: If you do not want to display programming on any other TV besides TV1 and you do
not want Remote Control 2 to control the receiver, select Disable View. After you select
Done, TV2 will show a screen that says Shared View is currently disabled.
MODULATOR SETUP
If you have TV1 and TV2 connected to the receiver with coaxial cables (see page 97), you
can decide which channel you’d like to use to view your DISH Network programming. If
you have the system locked, you’ll have to enter the password to enable TV1’s output on
this screen. Make sure your TV can tune to the channel you pick before you change the
setting on this screen.
USING MULTIMEDIA
Photos
You can display your photos on your television through your DISH Network receiver. Now
you don’t have to pass photos around or have a crowd of people hover around your digital
camera.
Chapter 11 Two Color.fm Page 86 Monday, December 19, 2005 1:02 PM