Filter
Top Products
Satellite Receiver
17
Remote Control
Remote Control Batteries
The remote control comes with AAA batteries. When you replace old
batteries, you should replace all of the batteries. Use batteries of the same
kind, for example, alkaline or carbon zinc. Don’t mix batteries of different
kinds. Alkaline batteries last longer.
1 Press down on the top of the battery cover and slide the cover off.
2 Take out all of the old batteries.
3 Put the new batteries in. Make sure you match the plus (“+”) ends with the
plus markings on the battery case.
4 Slide the cover back into place.
Low Battery Warning
When you see a low battery warning message on your screen below the Program Banner,
the batteries in your remote control are weak and need to be replaced.
Attach the Remote Antenna
Attach the UHF remote antenna to the receiver's back panel Remote Antenna input so you
can use your UHF Pro Remote Control 2. Without the UHF antenna, you cannot use the
remote to control the receiver. See Adjusting the Remote Antenna on page 74 for more
detailed information about improving the performance of your UHF Pro remote control.
Here's a helpful hint...Don’t wait until you see this warning to change the remote
control batteries. If your remote control doesn’t seem to be working very well (for
example, you have to press POWER more than once to turn the receiver on or off),
it’s a good indication that the batteries are getting weak.
Chapter 2 Two Color.fm Page 17 Tuesday, December 20, 2005 2:22 PM