Filter
Top Products
Connections and Setup
109
Connecting Off-Air Antenna
Scanning for Off-Air Channels
With your off-air antenna adjusted for best reception, use these instructions to scan for off-
air channels for the nearby TV.
1 Make sure you have your off-air antenna connected to the receiver’s 8VSB TV Antenna/
Cable connection.
2 Press MENU, select System Setup (6), and then Local Channels (9) to open the Local
Channels screen. If this is the first time you have opened this screen, it will have no
channels listed.
3 Scan for channels by selecting Scan Locals. When the Local Channels screen displays,
select Yes.
4 The scan will take a few minutes to complete. When it finishes, the results will show how
many channels the scan found.
5 Select OK to go back to the Local Channels screen.
Note: If the channel number says None, you have not yet assigned this channel a network
affiliation or name. The Arrow at the bottom left means that there are more channels, off
the bottom of the screen, which you can get to with the ARROW keys if you wish to edit
their names or remove them.
6 If you want to name the off-air channels, continue on. If you do not want to name your off-
air channels, select Done. You will then be taken out of the menus back to watching TV.
7 Select a channel and then select Edit Name to modify the way the channel name displays
on your screen.
8 Use the virtual keyboard on the screen to select the letters of your channel name.
9 When you are finished making changes, select Done.
Chapter 12 Two Color.fm Page 109 Tuesday, December 20, 2005 2:12 PM