Filter
Top Products
Connections and Setup
107
Connecting a VCR to the Remote TV
CONNECTING A VCR TO THE REMOTE TV
The diagram below provides example of how to connect VCRs to your satellite TV system.
For this installation, always leave your VCR powered on so that the TV can
receive satellite programming. If you turn off your VCR, your TV will not be
tuned to the correct channel to receive satellite programming.
Note: Connecting your TV directly to the satellite receiver provides the best audio and
video quality.
1 Connect the tuner input of the remote VCR to an existing wall cable outlet using a coaxial
cable.
2 Connect a coaxial cable from the output on the VCR to the remote TV’s tuner port.
3 Plug in and turn on the remote VCR and TV.
4 Tune the remote VCR to the remote TV channel that you use to watch satellite TV
programming (for example, channel 60) as set on page 102.
5 Write the channel number you tuned your VCR to in the previous step on one of the TV2
channel stickers. Place the sticker on or near the VCR. This sticker will remind you which
VCR channel to use to watch satellite programming. The stickers are located in the inside
front cover of this guide.
6 Set the VCR output to channel 3 or 4.
7 Tune the remote TV to the same channel that you set your VCR to in step 6.
8 Write the channel number you tuned your TV to in the previous step on one of the TV2
channel stickers. Place the sticker on or near the TV. This sticker will remind you which
channel to use to watch satellite programming. The stickers are located in the inside front
cover of this guide.
Chapter 12 Two Color.fm Page 107 Tuesday, December 20, 2005 2:12 PM