Filter
Top Products
69
System setup
3 Speaker
Parameter Value Function
Speaker
Switch
OFF, ON
This switches the internal speakers on/off.
* Even if this is set to on, no sound is played from the internal speakers during
recording standby or recording. The speakers also remain silent while headphones are
being used.
4 Display Setup
Parameter Value Function
Bright 1–5–10
This adjusts the Display contrast. Higher values emphasize the white areas of
the display.
Display
Timer
OFF, 2 sec,
5 sec, 10 sec,
20 sec
Sets the amount of time until the display becomes dark when no operations have
been performed on the R-44.
If you are operating the R-44 on battery power, use this setting to conserve bat-
tery life.
Button Light
Bright, Dim,
Auto
Sets the button brightness. When set to Auto, the button light darkens linked to
the set time of the Display Timer.
Illumination ON, OFF
All buttons are dimly lit. Button positions are easily verified even in dark loca-
tions.
5 System Setup
Parameter Value Function
Battery
Type
Alkaline,
Ni-MH
Sets the type of batteries you are using.
Choose the Alkaline setting if you are using alkaline batteries or Ni-MH if you
are using nickel metal-hydride batteries.
* If you choose a setting that does not match the type of batteries that are actually
installed, the remaining battery power indication will be incorrect.
Ext-Power
Adapter,
9.0/9.5/
10.0/10.5/
11.0/11.5/
12.0V
Sets the final voltage when using an external power source. The “Battery Low!”
message is displayed when the voltage of the external power source drops be-
low the set voltage and if the voltage drops further, the power automatically
turns off.
Output Sel
4-indiv
Sets the sound output type(p. 18).
The sound from each channel from LINE OUT is output without modification.
monitor Sound is output according to the output assignments
Sync Mode
Master
Sets the sync signal mode(p. 73).
These settings are for the transmission side.
Slave These settings are for the receiving side.
Project File WAV, BWF
This specifies the desired format of the project files created during recording or
editing. If you select WAV, a conventional WAV file will be created. If you se-
lect BWF, a BWF file containing information about the recording time and re-
cording device (EDIROL R-44) will be created.
R-44_e_new.book 69 ページ ２００８年１月７日 月曜日 午後５時８分