Filter
Top Products
78
Troubleshooting
Power does not turn on
• Make sure that the AC adaptor is correctly connected.
If using batteries, make sure that each battery is securely in place and in the correct orientation. It is
also possible that the batteries have run down, so you should obtain a new set of batteries.
Refer to: “Connecting the AC adaptor and turning the power on/off” (p. 24)
“Installing batteries and turning on the power” (p. 25)
• Make sure that the HOLD switch is turned off.
If power is turned on when the Hold switch is on, the Display shows “HOLD ON” and turns off
power.
Refer to: “Hold switch [HOLD]” (p. 10)
Finder operation is sluggish
If a folder contains a large number of files, operations are sluggish when you open the Finder, and the
screen does not scroll easily.
Try moving projects in the folder to a different folder so that the folder contains fewer projects.
Display is dark
The Display Timer setting in Display Setup sets the Display to go dark when the unit has not been operated
for a while.
Refer to: “4 Display Setup” (p. 69)
Settings disappear
If effect settings or system settings you made have reverted to their original state, it is possible that you
inadvertently reset the R-44 to its factory default settings.
Refer to: “Executing Factory Reset (Restoring factory default settings)” (p. 65)
Effect parameters that you set have been initialized
Effect parameter values are stored as long as the effect type is not changed; they will return to the default
values if the effect type is changed. If you have made detailed settings, you should make a note of those
settings to use them again.
Refer to: “Setting sound quality (Effects settings)” (p. 55)
Cannot operate the panel
Make sure that the HOLD switch is turned off.
If the HOLD switch is on, the panel buttons and the [SCRUB/VALUE] dial are inoperable.
Refer to: “Hold switch [HOLD]” (p. 10)
Project names and folder names in the Main screen or Finder are
garbled
The characters that are not “Available characters” are not displayed properly. In addition, RENAME may
not have been performed correctly.
Refer to: “Available characters” (p. 70)
Power turns off about 30 seconds after being turned on
The external power supply is depleted. Replace the external power supply with a new device or switch to
the AC adaptor. When using the AC adaptor, set the final voltage (Ext-Power) to Adaptor.
Refer to: “Setting final voltage” (p. 27)
Problems with R-44 operation
R-44_e_new.book 78 ページ ２００８年１月７日 月曜日 午後５時８分