Filter
Top Products
74
Messages
This section explains the most important messages that may appear in the R-44 Display
Message Status
Int-Batt Low!
The remaining charge for the internal battery is low.
The internal battery must be replaced. If the battery charge is insufficient, the internal clock will
become inaccurate but you can record, play and manipulate the other function correctly. Please
contact one of the service locations listed on the warranty card to have the battery replaced.
Battery Low!
The remaining charge for the batteries or the external power source is low.
Install fresh batteries, change the external power source, or use the AC adaptor.
SD buffering
The recording buffer has almost reached capacity. See p. 21 for details.
SD Card Slow!
The recording buffer has reached capacity. Recording does not stop, but some sound is not record-
ed. This message will not disappear until a button is pressed. If this message is displayed again, it
is possible that SD memory card processing capacity has decreased. Format the disk. See P. 20 for
details.
SD Unformatted
This message is displayed if SD memory card was formatted in a file format that the R-44 cannot
read. Please format the SD memory card.
SD Card Full!
There is insufficient free space on the SD memory card.
Transfer project files to your computer to free up more space.
SD Card Locked
The memory card is locked. Remove the memory card and unlock it.
SD Card Error
An error occurred while accessing the memory card. The memory card may be corrupted.
Over prj #999
This message is displayed if you press the record button when a project name with a number of
999 already exists. You cannot record in this state. You need to change the project name before
you can record.
Project exists!
An identically named project already exists.
Create the project using a different name.
File-Sys Error!
A problem has occurred with the file system.
Name too long!
The project name is too long.
This message is displayed if the project name newly created when you copy a project is too long.
You’ll need to shorten the name of the source project.
Improper Proj.
The R-44 cannot handle this project.
HOLD ON
The HOLD switch is on.
This message is displayed if you attempt to operate the R-44 while the HOLD switch is on.
Now Recording
The R-44 is recording now.
This message is displayed if you attempt to operate the R-44 during recording. If you need to
perform an operation, you must first stop recording.
Now Playing
The R-44 is playing now.
This message is displayed if you attempt to operate the R-44 during playback. If you need to
perform an operation, you must first stop playback.
R-44_e_new.book 74 ページ ２００８年１月７日 月曜日 午後５時８分