Hitachi DVRF7U DVD VCR Combo User Manual


 
Accessories
Check for the supplied accessories below.
Video/Audio Cable
RF Cable for TV
Remote Control
Instruction Manual
Batteries for Remote Control (AA Size)
Dispose of batteries according to local environmental
regulations. Do not put them in the household trash.
Method 1: Antenna + DVD Recorder-
VCR + TV: No Cable box
You can record non-scrambled channels by selecting the
channel on the DVD Recorder-VCR. Also use this Method if
you watch channels without cable box.
Method 2: Antenna + Cable box +
DVD Recorder-VCR + TV: Cable box with
many scrambled channels
You can record channels by selecting the channel on the cable
box. You cannot record one channel while watching another
channel. Be sure that the cable box is turned on.
To RF IN
To RF OUT
RF Cable
To ANT INPUT
ANT
TV
IN OUT
Cable box
Wall
OUT
RF
(TO TV)
IN
(FROM ANT.)
RF
To RF IN
To RF OUT
RF Cable
To ANT INPUT
ANT
TV
RF
(TO TV)
IN
(FROM ANT.)
OUT
RF
Connections
16 - English
Step 1: Unpacking
Step 2: Connecting the
Antenna Cable
There are several ways to connect your DVD Recorder-
VCR. Select one of the following antenna connections that
best suits you.
Method 1 : Antenna + DVD Recorder-VCR + TV : No
Cable box
Method 2 : Antenna + Cable box + DVD Recorder-VCR
+ TV : Cable box with many scrambled
channels
Method 3 : Antenna + DVD Recorder-VCR + Cable box
+ TV : Cable box with a few scrambled
channels
If you are using an off-air antenna that has 300-
ohm twin flat leads, use an external antenna con-
nector (300-75 ohm adapter: not supplied) to con-
nect the antenna to the DVD Recorder-VCR.
If you have two separate antennas (one VHF and
one UHF), use a UHF/VHF combiner-adapter
(available at most electronics shops) to connect the
antenna to the DVD Recorder-VCR.
The VHF/UHF RF OUT jack of this product sends
only signals received through the antenna. It does
not output audio/video signals. You must connect
audio/video cable to view Video from the unit. (i.e.
DVD playback)
Note