Filter
Top Products
Introduction
LitePro 560/570 User’s Guide 3
Remote Control Programmer Kit
The Remote Control Programmer Kit that was shipped with your
LitePro allows you to program the LitePro’s remote control to
perform up to four different operations on your computer. Refer to
the
Remote Control Programmer User’s Guide
for more information.
Usage Guidelines
• Do not look directly into the projection lens when the LitePro is
turned on! The bright light may harm your eyes.
• The back of the LitePro can be very hot to the touch after use. Use
extreme care or let it cool before lifting it.
• Do not block the grills at the back of the LitePro. Restricting the
air flow through the LitePro can cause it to overheat and turn off.
• Handle the LitePro as you would any product with glass
components. Be especially careful not to drop it.
• Avoid leaving the LitePro in direct sunlight or extreme cold for
extended periods of time. If this happens, allow it to reach room
temperature before use.
• Transport the LitePro in the original shipping box or approved
hard case (see your In Focus dealer for details on approved hard
cases).
If You Need Assistance
The first place to look for help is in this manual. Be sure to check the
troubleshooting guidelines in “Troubleshooting” starting on page 47.
If this manual does not answer your question, call your In Focus
dealer. You can also call In Focus Technical Support directly at
1-800-294-6400
. Call between 6 a.m. and 5 p.m. PST, Monday
through Friday. In Europe, call In Focus in The Netherlands at
(31) 23 5623200
.
Your LitePro is backed by a limited one-year warranty. The details of
the warranty are printed at the back of this manual.
INTRO.FRA Page 3 Tuesday, January 28, 1997 9:30 AM