Filter
Top Products
LitePro 560/570 User’s Guide iii
Safety Summary
Please read these instructions before using your LitePro projector.
Failure to comply with these instructions could result in fire,
electrical shock, personal injury or equipment damage.
These graphics are used throughout this manual to draw your atten-
tion to important information about the LitePro:
Information that may be unusual or unexpected.
Information that helps you avoid damage to your
equipment.
Information that helps you avoid personal injury.
These graphics are used on the LitePro:
Attention
- Refer to the User’s Guide for important
safety information.
Fuse
- Refer to “Replacing the Fuse” on page 43 of
this User’s Guide for important safety information.
Hot Surface
- Do not touch until the LitePro has
cooled.
Do not look into the lens!
Be very careful not to look into the projection lens when the projector
is turned on. The bright light may harm your eyes. Be especially
careful to keep children from looking into the lens.
Power Source
Use only a three-wire grounding type power source. The power
source should not exceed 250 volts rms between the supply
conductors or between either conductor and the ground.
Power Cord
Use only the power cord that was shipped with the LitePro.
Although other power cords might be similar in appearance, they
!
SAFETY.FRA Page iii Tuesday, January 28, 1997 9:29 AM