Filter
Top Products
17
Direct Measure Mode - ETA5 ONLY
(Ingersoll-Rand TRD, TSD or
Crane UTA Type Transducers)
Direct measure mode allows an operator to connect different transducers which may have differ-
ent spans and an angle output, and can switch between them using an external T switch. This is
a display only function and readings are not stored or printed out.
To start, press
press
press (Direct)
press (Direct Measure)
press (Setup)
select units of measure using ; press
select peak, track, Impulse or ‘Click Dip’ using ; press
select measurement direction using (Right is clockwise. Left is anti-clockwise);
press
select ‘Cycle end Time’ using ; press
select frequency response using ; press
type in the Threshold Percent (mx 50.0; mn 0.0), and press
type in amount of Click (mx 100.0 Nm; mn 0.0 Nm), and press
select ‘Second Parameter’ using ; press
Screen shows “End of Setup”, press to exit
press to return to main menu
ON
MENU
4
1
1
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
MENU
MENU MENU
7529_eng.fm Page 17 Wednesday, November 12, 2003 8:57 AM