Filter
Top Products
7
How to use this Manual
This manual is split into sections describing the steps to be taken to configure the
ETA for use in measuring and recording torque values.
There are a number of other parameters which are set from the Software Reset Menu, some of
which are detailed elsewhere in this manual.
Pressing after making a selection will take the user on to the next screen.
Pressing will give the user the option to exit to the Misc menu or continue to edit by
pressing .
Screens can be skipped using the and keys.
The following method is adopted throughout this manual.
Keys to be pressed will be shown as the key legend in large type: Example
Any special instructions or point to note will be shown as:
Refer to the table of contents to find action to be performed.
Follow instructions for key presses required to carry out required action.
Note: It is possible to change the default primary character on dual function
keys. ie: when text is entered into various fields, it is possible to set
the ETA to default to either the numerals or text as the primary char-
acter (the alternate character is selected by pressing the shift key
before typing). To set this:
From main menu:
Press then press (Misc)
Press then press (Software Reset)
Press the 7 times to access the ‘Shift key’ menu
Select between options 1 ‘Characters’ or 2 ‘Numbers’ using:
Press Screen will prompt “End of setup”
Press to return to main menu
Enter
MENU
Enter
Enter
INSTRUCTION
TO BE
FOLLOWED
6
6
MENU
MENU MENU
7529_eng.fm Page 7 Wednesday, November 12, 2003 8:57 AM