Filter
Top Products
58
Error Messages
Code Message Explanation
101 RANGE The selection made is not within the allowable
range. See the limits specified max to min.
104 EXISTS The characteristic name entered already exists.
105 NO SPACE Insufficient memory space is available to create a
new characteristic.
106 NONE No characteristics have been created.
107 ON PC Characteristic or round was sent from PC. These
may not be edited or erased on ETA.
108 CONV’ OUT
OF RANGE
The units selected would generate too great or
too small a number.
109 NO NAME A characteristic name must be entered.
110 NO SETUP The characteristic exists but configuration is not
complete.
111 NO DATA The characteristic exists, but no data is stored.
113 DAT STR More than one sub group of data is now stored.
114 ALL STR All of the sub groups for this characteristic have
now been collected. Erase these after printing to
allow further collection.
120 NO Tx Transducer has been selected but none is
connected.
121 TxID - FLT Transducer ID level not recognized. Use another
transducer or get transducer recalibrated.
122 AZ OFSET An auto-zero calibration on the transducer has
detected an excessive offset from zero.
7529_eng.fm Page 58 Wednesday, November 12, 2003 8:57 AM