Filter
Top Products
18
The READ option allows you to read the torque from a connected transducer.
From the main menu, press (Direct)
press (Direct Measure)
press (Read)
If no transducer is connected, display will prompt: “Insert Tx” (transducer)
connect transducer and press
Screen will show the span of the connected transducer and the torque measured in units
selected at setup. The display will show the last reading taken until the next torque input
exceeds the threshold level set.
Note: If password protection has been set on Direct measure, then exit is by
password only. A correct password returns you to the setup read sub-
menu. Entering three incorrect passwords will force the user back
into read mode. See password protection later in this book.
4
1
2
Enter
7529_eng.fm Page 18 Wednesday, November 12, 2003 8:57 AM