Filter
Top Products
23
To Store Data (single characteristic) - ETA5 ONLY
At main menu, press (Store)
press (Single Characteristic)
press
A job name will appear on screen. If more than one job has been set up in the ETA5, you can
scroll through the jobs in sequence using
You can also find your job by typing in the name after you press , then pressing
Alternatively, after pressing , when the cursor is flashing, you may connect a Bar Code
Reader to the Printer/PC connector on the back of the ETA5 and scan the information from a
barcode. Scan across the label (from left or right) and watch the display. If the flashing cursor
disappears, the reading has been captured; wait a few seconds for the reading to be displayed.
If not, re-scan until the data is accepted.
If a further reading needs to be taken, press to clear the data and allow a further scan
to be taken or data to be keyed in.
When correct job appears on screen, press
If you are using an Ingersoll-Rand TRD, TSD or Crane UTA type transducer and it is already
plugged in, you are now ready to take readings. The screen will show transducer size and Sub 1
Sam 1
If you are using any other type of transducer or it is not yet plugged in, you will be prompted to
insert transducer and select transducer type required.
Plug in correct transducer and press
When you have taken all readings, the screen will show that all torque collection is complete.
To return to the main menu, press
Note: When each reading is taken you will get an audible/visual signal.
3
1
Enter
1
Enter
1
Reset
Enter
Enter
MENU MENU
7529_eng.fm Page 23 Wednesday, November 12, 2003 8:57 AM