Filter
Top Products
44
Settings in the order they appear when the Software Reset Menu is accessed.
Cm max samples - type in the required figure
Cm min samples - type in the required figure
Language - select using
Autoprint mode - select using
Capability label - select using
Cpk Calculation - select using
Circle-store (On/Off) - select using
Shift key mode - select using
To Communicate with a PC
using PC Comms Software
Connect ETA5 to PC via cable provided
On PC, start PC Comms
On ETA5:
Press
Press
Press , then press
You can now setup and view all information/data via the PC
Note: This optional PC software is used primarily to write and store
characteristics and rounds on the PC. The format of the data
stored on the PC is of little use to the computer operator without
further processing.
On
MENU
8
7529_eng.fm Page 44 Wednesday, November 12, 2003 8:57 AM