Filter
Top Products
90
Search speed table (Supported speed only)
32 10
00 00
00 01
00 10
00 11
01 01
01 10
01 11
10 00
10 01
STILL
0.1
0.2
0.3
01 000.5
1
2
5
9 (10)
20
RS-232C INTERFACE – RS-232C commands – (continued)
Ⅵ D7: STATUS SENSE
This section describes 5-byte data that are re-
turned when the STATUS SENSE (D7H) com-
mand is sent.
7 Always 1
6 Always 0
5 SHORT FF/REW : In short FF or short REW
4 REC INHIBIT : Recording prohibited
3 CASSETTE OUT : No cassette tape loaded
2 SERO LOCK : Servo locked
1 Undefined : Always 0
0 ERROR : Error occurring
● First byte
7 VIDEO EE : Video output in the EE mode
6AUD EE : Audio 1 output in the EE mode
5 VIDEO MUTE : Video signals muted
4AUD MUTE : Audio signals muted
3WARNING : Problem with the VCR
2 DEW : Condensation in the VCR
1TAPE BEGIN : Short FF at the tape beginning.
0TAPE END : Short REW at the tape end
● Second byte
7 TIMER PLAY : TIMER switch set to PLAY
6 TIMER REC : TIMER switch set to REC
5Unused : Always 0
4 REPEAT : REPEAT PLAYBACK mode ON
3Unused : Always 0
2 REPEAT MODE : Repeat playback in operation
1 SEARCH MODE : VCR being cueing-up/prerolling
0Unused : Always 0
● Third byte
7 PLAY MODE : VCR playing
6 FF MODE : VCR fast-forwarding
5 REW MODE : VCR rewinding
4STOP MODE : VCR stopped
3STAND BY MODE : VCR on standby
2EJECT : Cassette tape being ejected
1 REC MODE : VCR recording
0 ADB MODE : VCR audio dubbing
● Fourth byte
7PAUSE MODE : VCR paused
6Unused : Always 0
5 SHUTTLE FWD : VCR forward shuttle-searching
4 SHUTTLE REV : VCR reverse shuttle-searching
3 SPEED CODE3 : Refer to the following table.
2 SPEED CODE2 : Refer to the following table.
1 SPEED CODE1 : Refer to the following table.
0 SPEED CODE0 : Refer to the following table.
● Fifth byte
Search speed
Bit No. Status: If the bit is 1
Bit No. Status: If the bit is 1
Bit No. Status: If the bit is 1
Bit No. Status: If the bit is 1
Bit No. Status: If the bit is 1
Speed code (Bit No.)
( ): PAL
DV6000U_72-104_Eng.p65e 06/03/03, 11:42 PM90