Filter
Top Products
Filename [HM-HDS4EK_04Basic.fm]
Masterpage:Left
14
Page 14 April 24, 2003 4:27 pm
INITIAL SETTINGS
Auto Set Up
Auto Channel Set/Auto Clock Set/
Auto Guide Program Number Set
A
Turn on the recorder.
Press
1
on the recorder or remote control.
NOTE:
For a few seconds after you pressed
1
, you can not stop Auto
Set Up, even if you press
MENU
to cancel this procedure.
B
Perform Auto Set Up.
The AUTO SET/T-V LINK display appears on the front
display panel and/or on the TV screen.
Slide
TV/CABLE/SAT
switch to the right.
?
Before starting, make sure of the following:
● The TV aerial cable should be connected to the recorder.
● The recorder’s mains power cord should be connected to a
mains outlet.
● The TV should be set to its AV mode.
After the
1
button on the recorder or remote control is
pressed for the first time to power on the recorder
, the Auto
Set Up function sets the tuner channels, clock and Guide
Program numbers automatically.
On the front display panel
Press
rt
to select “Auto”
and press
OK
or
e
.
On the on-screen display
Press
rt
to move the
highlight bar (pointer) to
“AUTO SET” and press
OK
or
e
.
“Auto” blinks on the front display panel; do NOT
press any button on the recorder or remote control
until the front display panel shows clock time,
“(CH) 1” or “– –:– –” as illustrated on page 17.
HM-HDS4EK_04Basic.fm Page 14 Thursday, April 24, 2003 4:29 PM