Filter
Top Products
Filename [HM-HDS4EK_04Basic.fm]
Masterpage:Left
40
Page 40 April 22, 2003 10:12 pm
RECORDING/PLAYBACK ON VHS DECK (cont.)
Repeat Playback
Your recorder can automatically play back the whole tape 100
times repeatedly.
1
Start playback.
Press
4
.
2
Activate Repeat Playback.
Press
4
and hold for over 5 seconds, then release.
● The Play indicator (
4
) on the front display panel blinks slowly.
● After playing back a tape 100 times, the recorder stops
automatically.
3
Stop Repeat Playback.
Press
8
at any time.
● Pressing
4
,
3
,
5
or
9
also stops Repeat Playback.
NTSC Playback
Your video recorder is equipped with NTSC circuitry that can
play back NTSC tapes.
1
Load a cassette.
Insert a cassette recorded in NTSC.
2
Start playback.
Press
4
.
● “NTSC→PAL” appears on the screen for about 5 seconds.
NOTES:
● Some TVs shrink the picture vertically and place black bars at
the top and bottom of the screen. This is not a malfunction on
the part of either the video recorder or the TV.
● The picture may roll up and down. This can be corrected using
the V-HOLD control found on some TVs. (This cannot be
corrected if the TV does not have a V-HOLD control.)
● The counter and tape remaining time readings will be
incorrect.
● During search, still, or frame-by-frame playback, the picture
will be distorted, and there may be a loss of colour.
● Depending on the type of TV, the top and bottom portions of
superimposed displays may be cut off during NTSC playback.
Index Search
Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
Activate Index Search.
Press
w
or
e
(
2
or
6
). “
2
1” or “
6
1” is
displayed on the TV screen and search begins in the
corresponding direction.
● To access index codes 2 through 9, press
w
or
e
repeatedly
until the correct index number is displayed.
Example:
To locate the beginning of B from the current position, press
w
twice.
To locate the beginning of D from the current position, press
e
once.
● When the specified index code is located, playback begins
automatically.
Next Function Memory
The Next Function Memory “tells” the recorder what to do after
rewinding. Before continuing, make sure the recorder is in the
Stop mode.
a-
For Automatic Start Of Playback
Press
3
, then press
4
within 2 seconds.
b-
For Automatic Cassette Ejection After Tape Rewind
Press
3
, then press within 2 seconds.
Current position
Index number
HM-HDS4EK.book Page 40 Tuesday, April 22, 2003 10:14 PM