Filter
Top Products
Filename [HM-HDS4EK_04Basic.fm]
Masterpage:Left
18
Page 18 April 22, 2003 10:12 pm
SAT CONTROL SET
Satellite Receiver
Control Setting
The following procedure is required if you receive
satellite channels through a satellite receiver.
Approximately 20 seconds before the VIDEO P
LUS
+ timer
programming (
੬
pg. 46) or Express timer programming
(
੬
pg. 48) starts, the recorder sets its input mode to “L-2”
and automatically switches the satellite receiver’s
channels using the provided Satellite Controller.
Installing Satellite Controller
A
Situate the Satellite Controller.
Place the Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
B
Attach the Satellite Controller.
Fix securely using the adhesive strip attached on the back
of the Satellite Controller.
C
Make connections.
Be sure to connect the recorder’s L-2 IN/DECODER
connector to the satellite receiver’s 21-pin SCART
connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
D
Connect the Satellite Controller to the
recorder.
Connect the Satellite Controller to the SAT
CONTROL
connector on the rear panel.
Satellite receiver
Satellite Controller
(suggested locations)
Transmitter
21-pin SCART cable
(provided)
Your recorder
Satellite Controller
Satellite receiver
Back of recorder
L-2 IN/DECODER
SAT CONTROL
HM-HDS4EK.book Page 18 Tuesday, April 22, 2003 10:14 PM