Filter
Top Products
Filename [HM-HDS4EK_05Timer.fm]
Masterpage:Left
46
Page 46 April 22, 2003 10:12 pm
TIMER RECORDING
VIDEO P
LUS
+
®
Timer
Programming
You can programme this recorder to timer-record as many as 16
programmes.
With the VIDEO P
LUS
+ system, timer programming is greatly
simplified because each TV programme has a corresponding
code number which your recorder is able to recognize.
A
Turn on the recorder.
Press
1
.
B
Load a cassette.
Insert a VHS (or S-VHS) cassette with the record safety
tab intact.
C
Access the VIDEO P
LUS
+ screen.
A
Press
PROG
.
B
Press
w
e
to move the arrow to “VIDEO PLUS+”, then
press
OK
.
● When “PROGRAMME FULL DELETE UNWANTED TIMER
PROGRAMME” appears on the TV screen, you need to cancel
some of the currently set programmes. (
੬
pg. 50)
D
Enter the P
LUS
C
ODE
number.
Press the
number keys
to enter the P
LUS
C
ODE
number of a
programme you wish to record.
OR
A
Press
w
r
e
t
to move the arrow to the desired
number key, then press
OK
.
B
Repeat step
A
to enter all needed numbers.
● If you make a mistake and needed to delete the last entered
number, press
w
r
e
t
to move the arrow to “DELETE”, then
press
OK
.
● To delete all entered numbers at the same time, press
w
r
e
t
to move the arrow to “DELETE ALL”, then press
OK
.
E
Select the recording deck, then confirm the
P
LUS
C
ODE
number.
A
Press
w
r
e
t
to move the arrow to “RECORD TO”,
then press
OK
.
B
Press
r
t
to select “HDD” or “VHS”, then press
OK
.
C
Press
t
to select “CONFIRM”, then press
OK
.
● If the number you entered is invalid, “PLUSCODE NO. ERROR
CONFIRM PLUSCODE NO. THEN RETRY” appears on the TV
screen. Input a valid P
LUS
C
ODE
number.
● If “SET GUIDE PROG THEN RETRY” appears on the TV
screen, set Guide Program Numbers (
੬
pg. 83) manually.
F
Check the programme data.
G
Set the recording speed.
A
Press
r
t
to move the arrow to “REC MODE”, then
press
OK
.
B
Press
r
t
to select the desire mode, then press
OK
.
Before performing the VIDEO P
LUS
+ Timer
Programming:
● Make sure that the recorder’s built-in clock is set properly.
● Turn on the TV and select the AV mode.
● Slide
TV/CABLE/SAT
switch to the right.
?
The P
LUS
C
ODE
number you
entered and the matching
timer-recording information
are displayed on the TV
screen. Check they are
correct.
● To cancel this setting, press
PROG
.
IMPORTANT
Make sure the channel position number you wish to record is
displayed; if not, see “VIDEO P
LUS
+
®
System Setup” on
page 83 and set the Guide Program number correctly.
HM-HDS4EK.book Page 46 Tuesday, April 22, 2003 10:14 PM