Filter
Top Products
Filename [HM-HDS4EK_04Basic.fm]
Masterpage:Left
16
Page 16 April 24, 2003 9:46 am
INITIAL SETTINGS (cont.)
Preset Download
Auto Channel Set by Downloading
from TV/Auto Clock Set/Auto Guide
Program Number Set
NOTES:
● For details, refer to the instruction manual of your TV.
● In the area where no TV station transmits a PDC (Programme
Delivery Control) signal, the recorder can perform neither
Auto Clock Set nor Auto Guide Program Number Set.
● If there is a power cut, or if you press
1
or
MENU
while
downloading or set up is in progress, it will be interrupted; be
sure to turn off the recorder power once and try again from
the beginning.
● Auto Clock Set may not function properly depending on the
reception condition.
● On this recorder, the characters available for station names
(ID) are A–Z, 0–9, –,
f
, + and
I
(space). Some names of
downloaded stations may differ from those of your TV
(
੬
pg. 90).
If you have connected the recorder to your TV via a 21-pin
SCART cable (
੬
pg. 12), the recorder will automatically
perform Preset Download instead of the Auto Set Up in step B
on page 14. After downloading, the recorder sets the clock and
Guide Program numbers automatically.
A
Turn on the recorder.
Press
1
on the recorder or remote control.
B
Perform Preset Download.
The AUTO SET/T-V LINK display appears on the TV
screen.
ATTENTION
You can use this function only with a TV offering T-V Link,
etc.* Be sure to use a fully-wired 21-pin SCART cable.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link or DATA LOGIC via fully-wired 21-pin SCART
cable. The degree of compatibility and available functions may
differ by system.
?
Press
rt
to move the
highlight bar (pointer) to
“T-V LINK” and press
OK
or
e
.
Preset positions on the front display panel increase from
“CH1”; do NOT press any button on the recorder or remote
control until the front display panel shows clock time,
“(CH) 1” or “– –:– –” as illustrated on page 17.
● If you are using the on-screen
display, the T-V LINK screen
will appear. Then the GUIDE
PROG SET screen will appear
during Guide Program
Number Set. When Preset
Download is completed,
“COMPLETED” appears for
about 5 seconds, then the
normal screen appears.
● If you press any button on the
recorder or remote control
while downloading is in
progress, it will be interrupted.
HM-HDS4EK_04Basic.fm Page 16 Thursday, April 24, 2003 9:48 AM