Filter
Top Products
Filename [HM-HDS4EK_06Edit.fm]
Masterpage:Left
68
Page 68 April 22, 2003 10:12 pm
EDITING (cont.)
Output/Input Set
L-1 OUTPUT and L-1 INPUT Setting
The L-1 IN/OUT connector accepts and delivers either a
composite signal (regular video signal) or a Y/C signal (a signal
in which the luminance and chrominance signals are separated).
Set “L-1 OUTPUT” and “L-1 INPUT” to the appropriate mode
depending on the type of appliance connected to the recorder’s
L-1 IN/OUT connector.
A
Access the Main Menu screen.
Press
MENU
.
B
Access the Input/Output Set screen.
C
Select the output or input mode for the L-1
IN/OUT connector.
A
Press
rt
to move the arrow to “L-1 OUTPUT” or “L-1
INPUT”, then press
OK
.
B
Press
rt
to select the appropriate setting, then press
OK
.
* The default setting is
bold
in the table below.
D
Return to the normal screen.
Press
MENU
.
NOTES:
● If “L-1 OUTPUT” is set to “S-VIDEO”, it is impossible to set
“L-1 INPUT” to “S-VIDEO”.
● If “L-2 SELECT” is set to “DECODER”, it is impossible to set
“L-1 INPUT” to “S-VIDEO”.
?
A
Press
w
e
to move the
arrow to “FUNCTION SET
UP”, then press
t
.
B
Press
w
e
to move the
arrow to “INPUT/
OUTPUT”.
8
L-1 OUTPUT
VIDEO
: If a connected appliance’s input is
compatible only with regular video
signals, set to “VIDEO”.
S-VIDEO:
If a connected appliance’s input is
compatible with Y/C signals, set to
“S-VIDEO”. You can obtain
high-quality S-VHS picture. (For
connection, be sure to use a 21-pin
SCART cable that is compatible with
the Y/C signal.)
8
L-1 INPUT
VIDEO
: If a connected appliance’s output is
compatible only with regular video
signals, set to “VIDEO”.
S-VIDEO
: If a connected appliance’s output is
compatible with Y/C signals, set to
“S-VIDEO”. You can obtain
high-quality S-VHS picture. (For
connection, be sure to use a 21-pin
SCART cable that is compatible with
the Y/C signal.)
HM-HDS4EK.book Page 68 Tuesday, April 22, 2003 10:14 PM