Filter
Top Products
Masterpage:Left-FullCol
82
Filename [HM-HDS4EK_07Sub.fm]
Page 82 April 22, 2003 10:12 pm
SUBSIDIARY SETTINGS (cont.)
FUNCTION
* The default setting is
bold
in the table below.
8
O.S.D.
ON
OFF
When this function is set to “ON”, various operational indicators appear on the TV screen.
NOTES:
● When you use this recorder as the source player for editing, be sure to set “O.S.D.” to “OFF” before
starting.
● During playback, the operation mode indicators may be disturbed depending on the type of tape
being used.
8
AUTO TIMER
ON
OFF
When this function is set to “ON”, the timer is automatically engaged when the recorder power is turned
off, and automatically disengaged when the recorder is powered back on.
NOTE:
For safety, when “AUTO TIMER” is set to “OFF”, all other recorder functions are disabled while the Timer
mode is engaged. To disengage the timer, press
#
(TIMER).
8
DIRECT REC
ON
OFF
When this function is set to “ON”, you can easily start recording the programme that you are watching
on your TV. Press and hold
7
and press
4
on the remote control, or press
7
on the recorder.
NOTES:
● When you use the Direct Rec function, be sure to use a TV offering T-V LINK, etc. and connect a
fully-wired 21-pin SCART cable between the recorder and the TV (
੬
pg. 12).
● If “DIRECT REC” is set to “OFF”, the
7
button functions as described in “Basic Recording” (
੬
pg. 22,
34).
● During the Direct Rec, “– –” appears on the front display panel.
● If a programme is recorded with the Direct Rec, the station name will not be registered for the
Navigation. “– – – –” will be displayed for the station name.
● Even if there is no power supply for more than 10 minutes, the recorder keeps the setting.
● If you use the remote control of your TV to record the programme with the Direct Rec, the programme
will be recorded on the HDD deck, even if you select the VHS deck. In this case, first few seconds of
the programme will not be recorded.
8
POWER SAVE
ON
OFF
When this function is set to “ON”, you can reduce the power consumption while the recorder is turned
off.
NOTES:
● During Power Save mode ...
... the front display panel will be turned off.
... the Just Clock function (
੬
pg. 84) does not work.
... the picture may be distorted momentarily when you turn on/off the recorder.
● Power Save does not work when ...
... the recorder is in the Timer mode.
... the recorder’s power is turned off after timer-recording or Instant Timer Recording.
... the Automatic Satellite Programme Recording mode is engaged. (
੬
pg. 51)
... “L-2 SELECT” is set to “DECODER” or “SAT”. (
੬
pg. 69)
● When this function is set to “ON”, any i.LINK device connected to the DV IN/OUT connector cannot
be recognized. As a result, it is not possible to record a programme using the digital turner’s timer
function.
● It takes some time for the recorder to complete initialize after you turn on recorder power.
HM-HDS4EK.book Page 82 Tuesday, April 22, 2003 10:14 PM