Filter
Top Products
Masterpage:Right-NoTitle0
95
Filename [HM-HDS4EK_07Sub.fm]
Page 95 April 22, 2003 10:12 pm
TIMER RECORDING
3. Tape-to-tape editing is not
possible.
●
The source (another video recorder,
camcorder) has not been properly
connected.
Confirm that the source is properly
connected.
●
All necessary power switches have
not been turned on.
Confirm that all units’ power switches
are turned on.
●
The input mode is not correct. Set the input mode to “L-1”, “L-2” or
“F-1”.
4. Camcorder recording is not
possible.
●
The camcorder has not been
properly connected.
Confirm that the camcorder is
properly connected.
●
The input mode is not correct. Set the input mode to “L-1”, “L-2” or
“F-1”.
5. “
⅜
” and “
$
” on the front display
panel won’t stop blinking.
●
The end of the tape was reached
during recording.
●
The programme may not have been
recorded in its entirety. Next time
make sure you have enough time
on the tape to record the entire
programme.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. Timer recording won’t work.
●
The clock and/or the timer have
been set incorrectly.
Re-perform the clock and/or timer
settings.
●
The timer is not engaged. Press
#
and confirm that “
#
” is
displayed on the front display panel.
2. Timer programming is not
possible.
●
Timer recording is in progress. Timer programming can’t be
performed while a timer recording is
in progress. Wait until it finishes.
3. “
#
” on the front display panel or
S-VHS indicator won’t stop
blinking.
●
The timer is engaged but there’s no
cassette loaded.
●
The cassette is ejected, then the
recorder is powered off
automatically after the end of the
tape is reached during timer
recording.
Load a cassette with the record safety
tab intact.
4. “
#
”, “
⅜
” and “
$
” on the front
display panel won’t stop blinking.
●
The loaded cassette has had its
record safety tab removed.
Remove the cassette and cover the
hole with adhesive tape, or insert a
cassette with the record safety tab
intact.
●
The end of the tape was reached
during timer recording.
The programme may not have been
recorded in its entirety. Next time
make sure you have enough time on
the tape to record the entire
programme.
HM-HDS4EK.book Page 95 Tuesday, April 22, 2003 10:14 PM