Filter
Top Products
Filename [M100_05Name.fm]
Masterpage:Left0
16 EN
INSTALLING YOUR NEW UNIT
It’s essential that your unit be properly connected.
1 Make sure the package contains all of the accessories listed in
“SPECIFICATIONS” (A pg. 69).
2 Place the unit on a stable, horizontal surface.
3 Connect the unit to a TV depending on the TV and cables you
use.
8 Simple Connections
To connect to TV’s VIDEO input and AUDIO input connectors
^
A Disconnect the TV aerial cable from the TV.
B Connect the TV antenna cable to the [ANTENNA IN] connector
on the rear panel of the unit.
C Connect the [ANTENNA OUT] connector on the rear panel of
the unit and the TV’s antenna connector with the supplied RF
cable.
D Connect the supplied video/audio cable between the [VIDEO/
AUDIO OUTPUT] connectors on the rear panel of the unit and
the TV’s VIDEO/AUDIO input connectors.
● Set your TV to VIDEO mode (or an input mode such as EXT1).
8 S-Video Connection
To connect to TV’s S-VIDEO input and AUDIO input
connectors ^
A Perform steps A – C of “Simple Connections”.
B Connect the unit’s [S-VIDEO OUTPUT] connector to the TV’s
S-VIDEO input connector.
C Connect the unit’s [AUDIO OUTPUT] connectors to the TV’s
AUDIO input connectors.
● You can obtain a high-quality S-VHS picture.
● If your TV is not stereo-capable, use the unit’s [AUDIO
OUTPUT] connectors to connect to an audio amplifier for Hi-Fi
stereo sound reproduction.
8 Component Video Connection
To connect to TV’s component video input connectors ^
A Perform steps A – C of “Simple Connections”.
B Connect the unit’s [COMPONENT VIDEO OUT (Y/P
B
/P
R
)]
connectors to the TV’s component video input connectors.
C Connect the unit’s [AUDIO OUTPUT] connectors to the TV’s
AUDIO input connectors.
● You can obtain high-quality component video pictures.
● If your TV is not stereo-capable, use the unit’s [AUDIO
OUTPUT] connectors to connect to an audio amplifier for Hi-Fi
stereo sound reproduction.
● By using the component video connection, you can view the
images in the progressive mode. For switching to the
progressive mode, refer to “Scan Mode Set” (A pg. 60).
4 Plug the end of the AC power cord into an AC outlet. This unit
performs Plug & Play Set automatically.
● ALOADINGB blinks on the front display panel when the AC plug
of the power cord is connected into an AC outlet. And it takes
approximately 30 seconds for the unit to be turned on. This is
not a malfunction.
NOTE:
It is necessary to connect any of above audio/video connections in
addition to antenna connection with RF cable in order to view DVD
playback on the TV.
Basic Connection
ATTENTION:
Connect the AC plug only after all connections to the TV has
been completed.
Antenna or Cable
Matching transformer (not
supplied)
Coaxial cable
AC Outlet
RF cable
(supplied)
To
[ANTENNA IN]
Video/Audio
cable (supplied)
Flat feeder
TV
AC Power Cord
To 75 ohm
terminal
Back of unit
Component
video cable
(not supplied)
To [S-VIDEO
OUTPUT]
To [VIDEO/
AUDIO
OUTPUT]
To
[ANTENNA
OUT]
To
[COMPONENT
VIDEO OUT (Y/
P
B
/P
R
)]
S-Video Cable
(not supplied)
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO
OPERATION CAN BE PERFORMED.
M100_00.book Page 16 Friday, February 18, 2005 6:23 PM