Filter
Top Products
Filename [M100_10Subsidiary.fm]
Masterpage:Left+
66 EN
TROUBLESHOOTING
Timer Recording
● Date and time is not correct.
] Set date and time correctly. (A pg. 17, 19)
● Timer recording is in progress.
] Timer programming can’t be performed while a timer recording
is in progress. Wait until it finishes.
● Date and time is not correct.
] Set date and time correctly. (A pg. 17, 19)
● Date and time is not correct.
] Set date and time correctly. (A pg. 17, 19)
● The channel position does not correspond to that in the
receiving area.
] Set the correct channel position for the receiving broadcast.
(A pg. 20)
● The unit’s channel positions have been set incorrectly.
] Refer to “Guide Channel Number Set” (A pg. 62) and re-
perform the procedure.
● The DBS receiver is not connected properly to this unit.
] Connect the DBS receiver correctly to the unit’s [L-1 INPUT]
connectors. (A pg. 42)
● Power failure occurred.
] Set date and time correctly. (A pg. 19)
● The PC’s data recorded on a DVD-RAM drive cannot be
cleared on this unit.
] Format the disc. (When the disc is soiled, wipe the disc with a
soft dry cloth before formatting.) (A pg. 11, 63)
Other Problems
] Press PROGRESSIVE SCAN for 3 or more seconds so that the
Video output indicator (q) lights off on the front display panel.
● The camcorder’s microphone is too close to the TV.
] Position the camcorder so its microphone is away from the TV.
● The TV’s volume is too high.
] Turn the TV’s volume down.
● Those channels have been designated to be skipped.
] If you need the skipped channels, restore them using “Manual
Channel Set” (A pg. 20).
● After the manual settings were made, Auto Channel Set was
performed.
] Do no perform Auto Channel Set after making manual settings,
proceed to perform “Clock Set” (A pg. 19).
] Reset the unit by disconnecting the AC power plug from the AC
outlet and connect again.
Timer programming cannot be made.
Timer programming recording does not start.
VCR Plus+ Timer Programming cannot be made.
The VCR Plus+ system does not timer record properly.
Automatic Satellite Programme Recording does not start.
On the front display panel, “- - : - -” appears.
The disc space does not increase when recorded titles are
cleared.
The image of the TV broadcast appears distorted on the TV
screen.
Whistling or howling is heard from the TV during camcorder
recording.
When scanning channels, some of them are skipped over.
Channel settings that were made manually seem to have
changed or disappeared.
Malfunction occurs and the unit cannot be power off.
M100_00.book Page 66 Friday, February 18, 2005 6:23 PM