JVC DR-M100S DVD Player User Manual


 
Filename [M100_09Editing.fm]
Masterpage:Left+
56 EN
EDITING
Page 56 Friday, 18 February 2005 18:22
You can dub selected audio from a DVD or Audio CD disc to a
digital audio device.
However, it is not possible to dub copy-protected discs.
Example: Dubbing to an MD
1 Connect the unit and a digital audio device using an optional
coaxial cable.
2 Place a disc on the unit and load an MD on the connected
digital audio device.
3 Select the audio to be dubbed.
4 Start playback slightly before the actual point from where you
wish to start dubbing.
5 Press W to pause playback.
6 Select the input mode on the connected digital audio device.
7 Press I to start playback on the unit.
8 Start recording on the digital audio device.
9 Stop recording on the digital audio device. Then press o to stop
playback on the unit.
NOTE:
There may be a discrepancy of several seconds between where
you intend editing to start, and where it actually starts.
Digital Audio Dubbing
Turn on the TV and select an input mode such as EXT1.
Rear of unit
Digital audio device (MD
deck, etc.)
Coaxial cable
(not supplied)
Player
Recorder
To [DIGITAL OUT
(COAXIAL)]
M100_00.book Page 56 Friday, February 18, 2005 6:23 PM