Filter
Top Products
Filename [SR-MV40U_08VCR Operation.fm]
Masterpage:Left+
46 EN
Page 46 November 25, 2005 11:19 am
OPERATIONS ON VCR DECK
1 Load a cassette with the record safety tab intact. If not, set
“REC SAFETY” to “OFF” (੬ pg. 73).
● The unit’s power comes on automatically and the counter is reset to
0:00:00.
2 Press VCR/DVD repeatedly so that the VCR lamp lights up on
the unit.
3 Press CH +/– or the number keys to select the channel you
wish to record.
4 Press REC MODE repeatedly to set the recording mode.
5 Press 7 on the unit to start recording. Or while holding 7, press
4 on the remote control.
● The VCR recording lamp lights up on the unit.
6 Press 9 to pause recording.
● You can select channel during the Record Pause mode.
● To resume recording, press 4.
7 Press 8 to stop recording.
● The VCR recording lamp lights off on the unit.
Recording Resume Function
If there is a power outage during recording or timer recording
(੬ pg. 46, 48, 49), the recording will resume automatically when
power is restored to the unit unless the unit’s memory backup has
expired.
Watch Another Program While Recording On The Unit
While recording is going on, you can watch another program on the
TV by using the TV’s tuner.
NOTE:
It is required that the remote control is set to be able to operate the TV
in advance. (੬ pg. 66)
1 During recording, press TV/VCR to select TV mode if your unit
is connected to the TV via the RF connection.
● VCR mode is disengaged, then the VIDEO indicator lights off and
“TV” appears on the front display panel.
● The program received on the TV’s tuner is displayed on the TV
screen.
2 Slide the TV/CABLE/DBS/DVD switch to TV.
3 Press CH +/– repeatedly to select the desired channel.
Basic Recording
● Turn on the unit.
● Turn on the TV and select the video channel (or AV mode).
● Slide the TV/CABLE/DBS/DVD switch to DVD.
Video Calibration takes place at the beginning of both the first
SP and the first EP recording after inserting the cassette.
(੬ pg. 47)
1
4
7
2
5
8
0
3
6
9
7
REC MODE
98
CH +/–
0 – 9
4
VCR/DVD
8 4 97
VCR/DVD
CH +/–
REC MODE
Recording Features
● Turn on the unit.
● Turn on the TV and select the video channel (or AV mode).
● Slide the TV/CABLE/DBS/DVD switch to DVD.
● Press VCR/DVD repeatedly so that the VCR lamp lights up on the
unit.
Accidental erasure prevention
To prevent accidental recording
on a recorded cassette, remove
its safety tab and set “REC
SAFETY” to “ON” (੬ pg. 73). To
record on it later, cover the hole
with adhesive tape or set “REC
SAFETY” to “OFF”.
1
4
7
2
5
8
0
3
6
9
CH +/–
DISPLAY
TV/VCR
CANCEL
VCR/DVD
7
8
4
7
8
VCR/DVD
VIDEO indicator lights off.
Record safety tab
SR-MV40US.book Page 46 Friday, November 25, 2005 11:19 AM