Filter
Top Products
Filename [SR-MV40U_10Editing.fm]
Masterpage:Left+
64 EN
Page 64 November 25, 2005 11:19 am
EDITING
You can use your unit as the source player or as the recording
deck.
NOTE:
When using another recorder as the recording deck, refer to its
instruction manual.
1 Make connections.
When using this unit as the recording deck
A If the another recorder has no S-VIDEO connector, connect the
unit’s [AUDIO/VIDEO INPUT] connectors to the audio/video output
connectors on another recorder.
B If the another recorder has S-VIDEO connector, connect the
[AUDIO INPUT] and [S VIDEO INPUT] connectors to the audio
and S-video output connectors on another recorder.
● If connecting a unit with an S-VIDEO connector, it is recommended to
use the supplied S-Video cable to minimize picture degradation while
editing.
2 Press VCR/DVD repeatedly to select the recording deck.
3 Press CH +/– to select “L-1” when using this unit as the
recording deck.
● Set “REAR AUX L-1” to “VIDEO” for the VIDEO input connector, or
“S-VIDEO” for the S-VIDEO input connector, depending on the
connector being used. (
੬ pg. 70) This setting is also applied to the
VCR deck.
4 For VCR deck only
Set “PICTURE CONTROL” to the appropriate mode. (੬ pg. 72)
5 Press REC MODE repeatedly to set the recording mode.
6 Engage the Play mode of the source player.
7 Engage the Record mode of the recording deck.
8 Stop recording on the recording deck, then stop playback on the
source player.
NOTES:
● All necessary cables can be obtained from your dealer.
● When you use this unit as the source player for editing, be sure to set
“SUPERIMPOSE” to “OFF” before starting. (੬ pg. 70)
● When you select “EDIT” to dub tapes in step 4, be sure to select
“AUTO” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”)
after you finish dubbing the tapes.
Edit To Or From Another Recorder
.
Player
Your unit
Another recorder
Recorder
TV receiver
Slide the TV/CABLE/DBS/DVD switch to DVD.
SR-MV40US.book Page 64 Friday, November 25, 2005 11:19 AM