JVC SR-MV40U DVD VCR Combo User Manual


 
Masterpage:Right+
EN 65
Filename [SR-MV40U_10Editing.fm]
Page 65 November 25, 2005 11:19 am
EDITING
You can dub selected audio from a DVD or Audio CD disc to a
digital audio device.
However, it is not possible to dub copy-protected discs.
Example: Dubbing to an MD
1 Connect the unit and a digital audio device using either an
optional optical cable or an optional coaxial cable.
2 Place a disc on the unit and load an MD on the connected digital
audio device.
3 Select the audio to be dubbed.
4 Start playback slightly before the actual point from where you
wish to start dubbing.
5 Press 9 to pause playback.
6 Select the input mode on the connected digital audio device.
7 Press 4 to start playback on the unit.
8 Start recording on the digital audio device.
9 Stop recording on the digital audio device. Then press 8 to stop
playback on the unit.
NOTE:
There may be a discrepancy of several seconds between where you
intend editing to start, and where it actually starts.
Digital Audio Dubbing
Turn on the TV and select the video channel (or AV mode).
Slide the TV/CABLE/DBS/DVD switch to DVD.
.
Rear of unit
Note for connection:
Remove the protection cap from the cable.
Digital audio device
(MD deck, etc.)
Coaxial cable
(not supplied)
To [DIGITAL AUDIO OUT
(COAXIAL)]
Player
Recorder
Optical cable
(not supplied)
To [DIGITAL AUDIO
OUT (OPTICAL)]
SR-MV40US.book Page 65 Friday, November 25, 2005 11:19 AM