JVC SR-MV40U DVD VCR Combo User Manual


 
Masterpage:Right+
EN 63
Filename [SR-MV40U_10Editing.fm]
Page 63 November 25, 2005 11:19 am
EDITING
You can use a camcorder as the source player and your unit as the
recording deck.
1 Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder’s AUDIO/VIDEO OUT connectors to the
unit’s [AUDIO] and [VIDEO] input connectors on the front panel.
When using a monaural camcorder, connect its AUDIO OUT
connector to the [AUDIO L] input connector on your unit.
B If the camcorder has an S-VIDEO output connector: (DVD deck
only)
— connect the camcorder’s AUDIO OUT and S-VIDEO OUT
connectors to the unit’s [AUDIO] and [S-VIDEO] input connectors
on the front panel.
2 Press VCR/DVD repeatedly to select the recording deck.
3 Press CH +/– to select “F-1”.
Set “FRONT AUX F-1” to “VIDEO” for the [VIDEO] input connector,
or “S-VIDEO” for the [S-VIDEO] input connector, depending on the
connector being used. ( pg. 70) This setting is also applied to the
VCR deck.
4 For VCR deck only
Set “PICTURE CONTROL” to the appropriate mode. ( pg. 72)
5 Press REC MODE repeatedly to set the recording mode.
6 Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
7 Press 7 on the unit to start recording. Or while holding 7, press
4 on the remote control. The dubbing starts.
8 Press 8 on the unit, then stop playback on the camcorder.
NOTES:
All necessary cables can be obtained from your dealer.
Refer to the camcorder’s instruction manual for operating procedure.
The quality of dubbed picture becomes poorer than that of the
original.
When you select “EDIT” to dub tapes in step 4, be sure to select
“AUTO” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”)
after you finish dubbing the tapes.
Edit From A Camcorder
A If the camcorder has no S-VIDEO output connector:
Recorder
AUDIO OUT
Player
Audio cable (supplied)
To [AUDIO] input
VIDEO OUT
Video
cable (not
supplied)
To
[VIDEO]
input
B If the camcorder has an S-VIDEO output connector (DVD
deck only):
Recorder
Audio cable (supplied)
S-VIDEO OUT
AUDIO OUT
Player
S-Video cable
(supplied)
To [AUDIO] input
To [S-VIDEO]
input
Slide the TV/CABLE/DBS/DVD switch to DVD.
SR-MV40US.book Page 63 Friday, November 25, 2005 11:19 AM