Filter
Top Products
10
• Circular cutter, Ø 38 mm
• Flat-bladed screwdriver for M5 screws
• Power drill
• Galvanised round head screws, depending on the roof structure (Ø: 5 mm, self-tapping screws D 7981,
depending on roof panel structure) or round head screws D 7985 with shims and nuts
• Twist drill, Ø 2.5 or 5.5 mm
• Round fi le and/or emery paper
• Cleaning agent
• Open-ended or ring spanners 10 and 11 mm across fl ats
• Knife
• Cross-head screwdriver for M3 and M5 screws
• Torque wrench capacity 6 to 11 Nm
• Allen wrench (5 mm)
• Two wooden beams for supporting the turntable
REQUIRED TOOLS AND EQUIPMENT
INSTALLATION AND CONNECTION
The CAP 910 must not be carried on the satellite dish, since this can cause the dish to distort.
Keep the device in its cardboard box for transport on to the vehicle roof. Only take the turntable out
of its packaging when it is on the vehicle roof. Retain the original packaging, as if it is necessary
to send the unit for repair transport damage cannot be ruled out and the manufacturer accepts
no liability for possible damage.
Loosen the six fastening screws (width A/F: 10 mm). Carefully lift the turntable off the mounting plate
and place it on the two prepared wooden supports. Make sure that the cables are not crushed where
they emerge from the underside of the turntable.
UNPACKING AND PREPARATION
Essentially, the cable lengths of the MobiSet 4 CAP 910 components allow you a free choice of
installation location on your caravan or motor home.
However, you should take note of the following points:
• Before installation, you should fi nd out whether the operating manual for your vehicle permits the
fi tting of non-vehicle-specifi c parts or what requirements need to be met in order to do so.
• For direct satellite reception, there should be no obstructions between the antenna and the satellite.
Therefore, make sure that the antenna is not shadowed by roof extensions such as luggage racks,
air conditioning units, solar panels, etc. The problem of shadowing applies also to the selection of
the parking place for your vehicle. For interference-free satellite reception, the antenna needs
a projected free view to the South at an angle of between 15° and 55° (depending on location)
to the horizontal.
SELECTING THE INSTALLATION LOCATION