Filter
Top Products
39
All settings on the UFS 940 are made using the remote!
IMPORTANT INFORMATION FOR CAP 910 BEFORE SETUP
REMOTE CONTROL
So as to avoid overheating the turntable motors, do not operate the motors
continuously for longer than 20 minutes.
None of the search procedures initiated by the CAP 910 will require as much as
20 minutes operation. Only repeated unsuccessful search procedures or manual
overrides by the user can cause this limit to be exceeded.
This section of the UFS 940sw operating manual for the turntable assumes that
the UFS 940sw and the turntable have been properly installed and connected,
as described in the installation and operating manuals.
If you have not yet done so, read the safety instructions at the beginning of the
UFS 940sw operating manual and follow them when handling the UFS 940sw and
the turntable unit.
Before setting up your satellite system, make sure that the location allows a free
view to the satellite positions to the South and is not shadowed by trees or other
obstructions. This will save you time and effort.
As soon as the ignition signal is no longer present at the turntable, if the receiver
is switched on the turntable will be supplied with a +12 V power supply and may
automatically move to the last known satellite position. Therefore switch your
receiver on only if you wish to use your CAP 910.
Reception
No reception